Flyzone FLZA3006 - Manual (Page 3)

3
Assemble the Fuselage
Non-permanent threadlocker
should be used on all screws
that thread into metal such as
the motor mount screws, the
set screws in the propeller hub
and the screws that secure the
spinner—a large amount of
threadlocker is not required—
just enough to “wet” the fi rst few
threads.
❏
1. Guide the motor wires through the oval hole in the bottom
of the motor mount. Then, mount the motor with the two 3 x
5mm screws (don’t forget to use threadlocker on the screws).
❏
2. Fasten the propeller hub onto the motor shaft using a
1.5mm hex wrench to tighten the set screws. Then, mount the
spinner with the 3 x 12mm screws.
❏
3. Connect the ESC to the motor and mount the ESC to the
inside of the fuselage with strips of the included adhesive-back
hook-and-loop material. Note: If, while running up the motor
later, the propeller turns backward, simply switch any two of
the three motor wires with each other to make the motor turn
the other direction.