Flyzone FLZA3006 - Manual (Page 4)

FLZA3006 Mnl Entire Contents © 2012 Hobbico, ® Inc. All rights reserved.
Champaign, Illinois (217) 398-8970
E-mail: [email protected]
™
4
❏
4. Apply a strip of the rougher, "hook-side" of the hook-
and-loop material to the bottom of the radio compartment for
the battery. Apply thin or medium CA all the way around the
edges of the strip to make certain it is adhered permanently.
❏
5. Same as was done with the aileron servos, temporarily
power up the elevator and rudder servos with your radio system
and make sure the arms are perpendicular.
❏
6. Install the pushorods through the guide tubes in the
fuselage. Then, connect the pushrods to the outer holes in
the servo arms. Glue the servos into position.
❏
7. Thread the clevises onto the pushrods until the end of
each pushrod protrudes through the clevis just enough to
become visible.
Congratulations! Your Calypso ARF
is now a Calypso Rx-R and you may
continue assembly using the full Calypso
instruction manual.