Flyzone FLZA3342 - Manual (Page 7)

7
power switch for both transmitters to the OFF position. This
will terminate the wireless link between both transmitters. If
additional training will be performed again, return to step 1
above to re-establish the wireless link between the teacher
and student’s transmitters.
Bind the Receiver to the Tx
For proper operation it’s necessary to “bind” the Tx and Rx
together electronically. This ensures sole communication
between the two, and prevents other transmitters from being
able to control the receiver.
1. Turn on the Tx.
2. Apply power to the Rx.
3. If the Rx LED fl ashes once and then stays on, the
Rx is already bound to the Tx and you can skip to
the next section. Otherwise, insert a small diameter
screwdriver through the hole marked “BIND” and
press the pushbutton until the Rx LED glows red and
then turns off after about one second.
4. Release the “BIND” button.
5. If the binding is successful, the Rx LED will fl ash once
and then remain ON.
6. Test for proper Tx / Rx functionality in the next section.
If the radio doesn’t appear to have become properly
bound, repeat steps 1– 6 above.
Failsafe Function
The included TR624 receiver has a failsafe feature which
engages in the event that the radio signal from the transmitter
somehow becomes interrupted. This safety feature causes the
servos to automatically move either to a certain position, or
hold their last position so to prevent the model from moving in
an erratic manner. Channels 1, 2, and 4 will enter a “hold” mode,
whereby the servos will lock in their last recognized position.
Channel 3 will move to a pre-set position. The factory default
failsafe position for channel 3 is to move the throttle to 0%.
Motor/prop movement should stop if the receiver loses signal
from the transmitter. The throttle servo’s failsafe position can
be manually re-set to any other position if desired, as follows:
IMPORTANT NOTE: Before manually resetting the
failsafe, make sure the servo reversing switches are in the
correct position for the application.
1. Apply power to the Tx and Rx.
2. If using an ESC, do NOT arm the ESC. Do NOT attempt
to adjust the throttle’s failsafe position if the ESC is
armed. (Disconnect one of the three motor wires to
disable the motor.)
3. Move the Tx throttle stick to the desired position for
the throttle control to move if the Rx goes to failsafe
(otherwise this process may arm the motor).
4. Press and hold the “Bind” button on the receiver, and the
Rx’s LED should blink twice. Release the Bind button,
and the receiver’s LED should turn on (stop fl ashing).
The Tx and Rx should now be bound, with the throttle
failsafe in the new position as set above.
FINAL SETUP
The canopy hatch is held securely to the plane with strong
magnets. To avoid damaging the foam material when removing
the canopy hatch, reach your fi nger up through the cooling
hole on the underside of the fuse and push it off.
The fi n easily connects to the plane with magnets. Align the
fi n into the slot and it will click into place.