Flyzone FLZA2052 - Manual (Page 6)

6
Illuminated red light
indicates the TTX402
is powered and transmitting.
Center the rudder and
elevator trims.
Leave the left stick
(throttle control) in
the minimum position
during setup.
Power switch “ON”.
TRIM ADJUSTMENT
Full extent............. Centered ........... Full extent
Constant «beep» .....Single «beep» ..... Constant «beep»
POWER THE TTX402 AND CENTER THE TRIMS
LINKING TO MICRO TX-R AIRCRAFT
Micro Tx-R aircraft include a receiver that auto-links to a Tactic transmitter. Once the receiver is powered, it will
link automatically to a present and compatible Tactic SLT 2.4GHz signal. Please follow these steps to safely link
your transmitter and aircraft the fi rst time.
1. Always power the transmitter or AnyLink fi rst.
2. Plug in the battery to the aircraft.
HELPFUL TIP: Before going to fl y with a group, pre-link your transmitter and receiver prior to arriving at the
fl ying location.This must be done in an environment free of Tactic SLT 2.4GHz signals. Pre-linking ensures that
familiarity is established between your transmitter and receiver. Familiarity guarantees that as long as your
transmitter is powered fi rst, your receiver will link to your transmitter regardless of the other compatible signals
in the environment.
NOTE: Only AnyLink-compatible computer transmitters will allow the right stick to control the
micro aircraft’s rudder by utilizing a programming mix. Refer to your computer transmitter
instruction manual to confi gure your transmitter or visit Tx-Ready.com for programming tips.
AnyLink must be in Normal Mapping (1 Beep) when Futaba ® , Hitec ® or Tower Hobbies
transmitters are used with Tx-R aircraft. If using a Spektrum ® or JR ® transmitter, AnyLink
must be in Alternate Mapping (2 Beeps).
TX-R ONLY: POWER ANYLINK OR A TACTIC 2.4GHZ TRANSMITTER
All trademarks are property of their respective owners.