Flyzone HCAA23 - Manual (Page 8)

❏ 4. With the transmitter and plane turned on, center the
elevator, rudder, and aileron sticks and trim levers.
Confirm that the control surfaces are in the neutral
position using a straight edge. If not, loosen the locking
screws in the pushrod connectors, adjusting the pushrod
as necessary, and retightening the screws.
The throws are measured at the widest part of the
elevator and rudder. Adjust the position of the pushrods
at the servo arms and the control horns to change the
amount of throw. Moving the pushrod out away from
the center of the servo arm or in on the control horn
will increase the amount the control surface moves.
❏ 1. When viewing the airplane from the aft end,
move the left control stick to the left. The rudder must
move to the left. If it does not, change the position of
the rudder servo reversing switch on the transmitter.
When the left stick is moved all the way left, the
trailing edge of the rudder should move to the left
3/8" [10mm]. When the left stick is moved all the way
right, the trailing edge of the rudder should move to
the right 3/8" [10mm].
❏ 2. By moving the right stick down, the elevator must
move up. If it does not, change the position of the
elevator servo reversing switch on the transmitter. When
the right stick is moved all the way down (towards you),
the trailing edge (back edge) of the elevator should
move up 5/16" [8mm]. When the right stick is moved all
the way up (away from you) the trailing edge of the
elevator should move down 5/16" [8mm].
CHECK THE CONTROL THROWS
8