Flyzone HCAA42 - Manual (Page 7)

7
❏
7. Snap the plastic retaining clip into position over the
bottom of the fi n post. Pull up on the base of the fi n to make
sure the assembly is securely clamped into position.
Hook Up the Controls
❏
1. Temporarily take the receiver part way out of the
fuselage just enough so you can hold it in your fi ngers.
Connect the elevator, throttle and rudder servo wires to the
receiver according to the labels on the end of each wire. The
wire labelled “2” is the elevator and goes to the receptacle
in the receiver labeled “2.” “3” is the electronic speed control
(ESC) for channel 3 (throttle), and “4” is the rudder. Note that
the black wire in each connector goes forward.
❏
2. Temporarily replace the receiver into its molded-in
cubby in the fuselage (but don’t remove the backing from
the adhesive foam tape on the back of the receiver yet—
there will be more wires to connect later when mounting
the wing).
❏
3. Read the following battery cautions. Then, install eight
AA batteries in the transmitter.
• Do not use rechargeable (NiCd)
batteries in this transmitter.
• Do not mix old and new batteries.
❏
4. Center the aileron, elevator and rudder trims on the
transmitter, but lower the throttle trim and the throttle stick
(so the motor will not turn).