Fredenstein Bento 10D - Manual (Page 3)

Fredenstein Bento 10D Module Carrier
Operation:
After installation of the modules, connect the mains cord to the Bento 10D IEC socket located on
the back-panel and than connect the mains cable to a grounded outlet. Now turn the Bento 10 on by
operating the I/O switch (also part of the IEC socket on the back). The following screen will be
displayed indicating the status and power-supply voltages.
Now the Bento 10D is ready and will display any request from certain
Fredenstein modules.
To enter the setup menu, please push the wheel and the setup menu will
appear.
Configuration of audio linking
Configuration of compressor buss linking
Save Configuration
Recall Configuration
Enable/disable ground lift
Set display brightness and dimming
Exit menu system
Turning the wheel left or right to scroll from one menu point to the next, the highlighted menu point
will get selected when the wheel is pushed. Selecting Exit and pushing the wheel will show the
Status screen again.
In the audio menu the input signal for slots 2 to 10 can be selected. (Slot 1 always gets its input
signal for the XLR connector located on the back-panel). By turning the wheel the desired slot can
be selected and by pushing the wheel the value toggles between XLR for the slots input XLR
connector or the output of the slot to its left. Selecting Exit will show the Setup Menu again.
Fredenstein Bento 10D Manual V2.0 September 24, 2014 Page 2