Futaba 3PDF - Manual (Page 34)

Description of Functions
Channel 3 Function Selection
The channel 3 operation can be selected from the follow-
ing functions.
1P: The third channel will operate like a self return switch. The servo will
move from servo position (P1) when the lever is not operated to servo
position (P2) while the lever is operated. This function is convenient
when a on board engine is used.
2P: Channel 3 operates like a 2-position Lever operation moves the
servo to two positions: servo position (P1) and servo position (P2).
The servo stops at each function.
3P: Channel 3 operates like a 3-position switch. Lever operation moves
the servo to three positions: servo position (p1) servo position (P2)
and servo position (P3). The servo will stop at each position.
4P: lever operation moves the servo to four positions: servo position (P1)
servo position (P2) servo position (P3) and servo position (P4). The
servo stops at each position.
Lin: lever operation moves the servo from the R (right side) to L (left side)
in steps This is convenient when FET Amp MC510CB with current
control Is used.
1
Access the System Mode by pressing the Mode
and Select key simultaneously.
(Setup Screen Selection)
2
Access the channel 3 function by pressing the
Mode key two times.
(Function Selection)
3
Select the desired function with + or - key.
Travel and Servo Position Setting
Set the LIN type maximum travel and the 1P~4P type
servo position at the CH 4 position display screen
Position Movement Direction
When 1P~4P type is selected the direction of the move-
ment by lever operation can be changed with the servo
reversing function
SELECT
MODE
MODE
1:
10.5V
SYSTEM
MODE
REVERSE
AUX.SEL
GD.SELCT
MDL.NAME
SELECT
MODE
MODE
MODE
MODE
MODE
MODE
Initial Screen
Select key
pressed first
System Mode
Group