Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 78)

78
Fu
n
c
tio
n
Mixing Menu
Mixing Menu (Steering,Throttle,3rd,4th channel system)
Big cars such as 1/5 scale GP car, etc. brake mixing, 4-wheel steering 4WS mixing used
with Corolla, etc., dual ESC mixing that controls the front and rear motors independently,
gyro mixing that allows adjustment of the sensitivity of Futaba car rate gyros, CPS mixing
that controls Futaba channel power switch CPS-1, and other special mixing functions and
program mixing that allows free setting among channels can be set at the mixing menu.
Program, mixing
These functions allow you to apply mixing between the steering, throttle, channel 3 and
channel 4.
Steering mixing
This mixing function uses 2 servos to individually control the left and right steering. Left
and right steering can be set independently so smooth cornering is possible.
Brake mixing
This function is used when the front and rear brakes must be adjusted independently such
as a 1/5 scale GP car.
Gyro mixing
This function is a remote gain function that uses the 3rd or 4th CH of the transmitter to ad-
just the sensitivity of a Futaba car rate gyro. It can also be used by switching the two gains
mode by switch. Normal mode and AVCS mode are explained at gyro mixing.
4WS mixing
This function can be used with Corolla and other 4WS type vehicles. It is mixing that uses
the 1st CH to control the front side steering and the 3rd or 4th CH to control the rear side
steering. OFF (front side only), reverse phase, same phase, rear side only and other 4WS
types are switched by switch.
Dual ESC mixing
This function is mixing that uses the 2nd CH to control the front side motor controller and
the 3rd or 4th CH to control the rear side motor controller of a Corolla or other 4WD type
vehicle. Drive is switched among front side only, rear side only, and both front side and rear
side (4WD) by switch.
CPS mixing
This function controls the Futaba CPS-1 channel power switch.
Normally, when a CPS-1 unit is used to light the chassis dress-up and other illumination
(LED) the LED is connected to a vacant switch channel of the connected CPS-1 unit and
the LED is turned on and off by switch while the vehicle is running. However, when this
&36PL[LQJIXQFWLRQLVXVHGWKH/('FDQEHWXUQHGRQDQGRIIDQGDOVRÀDVKHGLQVWHSZLWK
steering and throttle operation, as well as being turned on and off by switch.
Tilt mixing
Tilt mixing uses an outboard engine and applies bidirectional mixing from rudder (steering)
WRÀDSDQGIURPÀDSWRUXGGHUVRWKDWZLWKDERDWUXGGHURSHUDWLRQDQGWLOWPL[LQJRSHUD-
tion can be performed by 2 servos.