Futaba 9CPS - Manual (Page 69)

GOAL of EXAMPLE: STEPS: INPUTS:
69
Adjust travels as needed to match
model’s recommended throws (usually
listed as high rates).
P. 32.
Set up dual/triple rates and exponential
(D/R,EXP)
P. 35.
(Note that in the middle of the left side
of the screen is the name of the channel
and the S
WITCH position you are
adjusting. Two or even three rates may
be set per channel by simply choosing
the desired S
WITCH and programming
percentages with the S
WITCH
in each of
its 2/3 positions.)
Move flap control from the VR(A) dial
to the left slider [VR(D)]. (AUX-CH)
p. 39.
Where next?
In the BASIC menu, choose END POINT.
Adjust the servos’ end points.
(Ex: flap servo)
Close the function.
Choose D/R,EXP.
Choose the desired control, and set
the first (Ex: high) rate throws and
exponential.
Set the second (low) rate throws and
exponential.
Optional: change dual rate S
WITCH
assignment. Ex: elevator to S
WITCH
G
with 3 positions.
In the BASIC menu, open AUX-CH.
Choose CH6 (flap).
Change primary control to VR(D).
Change other channels as needed.
Return to the home screen.
2 steps to END POINT.
to choose END POINT.
to FLAP.
VR(A) until travel as desired.
VR(A). Repeat as needed.
to D/R,EXP.
to choose D/R,EXP.
to CH>.
to choose CH>2 (elevator).
A to up position.
[Note screen reads ELEV (UP)]
to D/R.
E LEVATOR S TICK . to set.
E LEVATOR S TICK
. to set.
(Normally the same for both directions.)
to EXP.
E LEVATOR S TICK . to set.
E LEVATOR S TICK
. to set.
to D/R. A to down position.
Repeat above to set low rate.
to SW. to G. G to
center position.
Repeat steps above to set 3rd rate.
to AUX-CH. to choose AUX-CH.
to CH6.
to VR(D).
Repeat as required.
(Other functions you may wish to set up for your model.)
TRAINER p. 40.
Multiple wing or tail servos. See wing types and tail types: p. 44, 49.
START and SPEED OFFSETS, BUTTERFLY (AIRBRAKE/crow), and other
programmable mixes p. 54.
Retractable Gear, Smoke systems, kill switches, and other auxiliary channel
setups: p. 39.
Adjusting
SUB-TRIMs to match servo centers: p. 42.