Futaba R616FFM - Manual

For Parkflight and Indoor Use Aircrafts
R616FFM
Thank you for purchasing the R616FFM FASST 6(six)
channel receiver. This model is designed for use of parkflight
or indoor use aircrafts.
The R616FFM is compatible with the FASST transmitters as shown below.
T6EX, T7C, TM7, TM8 (on 7ch mode) , TM10 (on 7ch mode) , TM14 (on 7ch mode)
Usage Precaution
• The R616FFM is especially designed for short range application like parkflight or in-
door aircrafts.
• Please be sure that the ESC's regulated output for receiver has enough capacity to
sustain the entire operating condition of your servos, battery, and motor.
• After the linking is done, please cycle receiver power and check if the receiver to be
linked is really under the control by the transmitter to be linked.
• Please do not perform the linking procedure with motor's main wire is connected or
the engine is operating as it may result in serious injury.
Connectors
1: CH1 servo
2: CH2 servo
4: CH4 servo
5: CH5 servo
6: CH6 servo
3/MC: CH3 servo
/ESC connector
LED Easy Link Button
Antenna
MICRO CONNECTOR
Compliance Information Statement (for U.S.A.)
This device, trade name Futaba Corporation of America, model number
R616FFM, complies with part15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesiredoperation.
The responsible party of this device compliance is:
Futaba Service Center
3002 N Apollo Drive Suite 1, Champaign, IL 61822 U.S.A.
TEL (217)398-8970 or E-mail: [email protected] (Support)
TEL (217)398-0007 or E-mail: [email protected] (Service)
R616FFM (MICRO CONNECTOR)
[ Specifications]
• Power requirement: 4.8V or 6.0V battery or regulated output from ESC, etc.
• F/S and Battery F/S function (for channel three)
• Battery F/S voltage: 3.8V
• Size: 39.0x23.0x7.9mm (1.54x0.91x0.31in.)
• Weight: 6.3g (0.22oz.)
Antenna Precaution
 WARNING
 Never cut or fold the antenna as it
may cause shorter range.
 Keep away from a large metal ob-
jects like batteries as it may block
the RF link to the R616FFM.
Easy Link Switch
Press and hold,
1
One(1) second to re-set F/S position for 3ch.(with TM7, TM8)
2
More than two(2) seconds to re-link the transmitter's ID.
Range Check the Radio
1
Please follow the transmitter's instruction manual and check if the range is
over 30 paces.
FUTABA CORPORATION Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan
©FUTABA CORPORATION 2011, 07 (2)
LED Indication
Green Red Status
Off Solid No signal reception
Solid Off Receiving signals
Blink Off Receiving signals but ID is unmatched
Alternate blink Unrecoverable failure (EEPROM, etc.)
1M23N21204