Tape, Recording, Recording -22 – Philips FW 72C User Manual

Page 21: Tape aux recording, Selecting external equipment, One touch recording

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TAPE

AUX

RECORDING

2

Press STOP ■ to stop rewind or fast forward.

During playback

• Press and hold or ► ► respectively until the desired

passage is located.

-* During searching, the sound is reduced to a low

volume.

-*• When you release or the tape continues

playing.

Notes:
- During rewinding or fast forwarding, it is possible to

select another source (e.g. CD, TUNER or AUX ).

~ Check and tighten slack tape with a pencil before use.

Slack tape may get jammed or may burst in the

mechanism.

- C-120 tape is extremely thin and may be deformed or

damaged easily. It is not recommended for use in this
system.

- Store the tapes at room temperature and do not put

them too close to a magnetic field (for example,
transformer, TV or loudspeaker boxes).

Selecting External Equipment___________

If you have connected the audio out terminals of the
external equipment (TV, VCR, Laser Disc or DVD player) to

the AUX ll'J terminals, you can hear the sound from the
system.

• Press AUX to select the external mode.

RLI-" will be displayed.

Note:

All the sound control features (e.g. DSC, DBB, etc.) are

available for selection.

Notes:
- For recording, use only tape of lEC type I (normal tape)

or lEC type II (Chrome).

-

The tape Is secured at both ends with leader tape. At

the beginning and end of tape, nothing will be

recorded for six to seven seconds.

-

The recording level is set automatically, regardless of

the position of VOLUME or DBB.

- To prevent accidental recording, break out the tab on

the left shoulder of the tape side that you want to

protect.

- I f ' С Н Е С И T Н Р С " is displayed, the protection tab

has been broken. Put a piece of clear adhesive tape
over the opening. Do not cover the CrO^ tape detection
hole when covering the tab opening.

One Touch Recording__________________

• For One Touch Recording, as soon as you press

RECORD,

the current source will be recorded on tape

deck 2.

1 Load a blank tape in tape deck 2.
2

Press RECORD to start recording.

— The RFC flag starts flashing.

3

Press STOP ■ to stop recording.

Note:
- When you press RECORD at TAPE mode,
'GO L C C T

u T H C P S u i l R C C " will be displayed. One Touch

Recording is not possible at TAPE mode.

21

Advertising
This manual is related to the following products: