Philips FW-C500 - Manual (Page 37)

CD Operation
Disc Playback
To playback all discs on the disc tray
Press PLAY ►
All the available discs will playback once, then
stop.
During playback, the selected disc tray track
number and elapsed playing time of the current
track will appear on the display.
To playback one disc only
Press the DISC DIRECT PLAY button : DISC 1,
DISC 2 or DISC 3
-> The selected disc will playback once, then
stop.
To interrupt playback
Press PAUSE II
To resume playback, press PLAY ► again.
To stop playback
Press ■.
To search for a particular passage during
playback
Press and hold or ►► and release it when
the desired passage is located.
During searching, the volume will be reduced.
To select a desired track
Press N or H repeatedly until the desired
track appears on the display.
If playback is stopped, press PLAY ►to start
playback.
Note:
- In Shuffle mode, pressing M will cause the
player to skip only to the beginning of the current
track.
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order
1 Load the desired discs on the disc tray (refer to
"Loading Discs").
2 Press PROG to start programming.
PROG will start flashing.
3 Press CD (CD 1 *2-3) or DISC 1/2/3 button
to select a disc.
4
Press
M
or
N
repeatedly to select the desired
track.
5 Press PROG to store the track.
• Repeat steps 3-5 to store other discs and
tracks.
6 Press PLAY ►to start program playback.
-> "PL’n'o PRu'oRRiT’ will be displayed.
• To end programming without starting playback,
press ■ once ,
The total number of tracks programmed and
the total playing time will appear on the display
Notes:
- If the total playing time is more than "9
S '
b 9
"
or
if one of the programmed tracks has a number
greater than 30, then
"
will appear on the
display instead of the total playing time.
- If you attempt to program more than 40 tracks,
"riTuuf?Ri'1 rL'iLL" will be displayed.
- If you press any of the DISC DIRECT PLAY
buttons, the system will playback the selected disc
or track, and the stored program will be ignored
temporarily. The prog symbol also will disappear
temporarily from the display. It will reappear when
playback of the selected disc ends.
- During programming, if no button is pressed
within 20 seconds, the system will exit the Program
mode automatically.
To skip to the beginning of the current
track during playback
Press N once.
To review the program
Stop playback and press N or ►! repeatedly.
To exit review mode, press ■ .
To replace discs during playback
1
Press DISC CHANGE
2
To change the inner disc, press DISC
CHANGE again.
-> "TIGiL ThIrliJPif" will be displayed and the
disc will stop playing.
-> The disc tray will close to retrieve the inner
disc, then reopen with the inner disc accessible.
To erase the entire program
Press ■ once when playback is stopped or
twice during playback.
-» L'LLRPEI j '' will be displayed.
^ PROG will disappear from the display.
18