Philips AQ 6549/00 - Manual (Page 4)

Radio
SUPPLY RADIO RECEPTION
Batteries
• Insert two alkaline batteries as indicated, type
R6, UM3 orAA.
• Remove the batteries if they are exhausted or if
they are not to be used for a long time.
Mains adaptor
• Connect a mains adaptor to the 3 V DC socket.
• The adaptor must supply 3 V DC ©-€>-©, minus-
pole © to the 1.3 mm centre pin of the 3.4 mm
socket.
Remarks: When you use the set for the first time
or when you have left the set without batteries for
a long time, the display may show incorrect infor­
mation, or the preset stations may not be received
correctly. If this is the case, pressing a ballpoint pen
through the hole in the back of the set enables you
to reset the display and to re-programme the preset
stations.
Sometimes, the preset stations and the clock time
have to be re-programmed after changing the
batteries.
9/10 kHz switch for AM (=MW)
Important: You must set 9/10 kHz switch to the
correct position before use:
• 10 kHz - for use in North and South America.
•
9 kHz - for use in all other countries.
• Set НАСЮЯАРЕ to RADIO.
• Connect the headphones to ¡Ti. The headphone
lead will function as FM-aerial.
• Select the wave band using FM»AM. The display
shows 'FM' or 'AM'.
• In case of FM, set FM ST/FM (mono) to the
desired position.
- When 'stereo' appears on the display, you are
listening to FM stereo programmes in stereo.
The disturbance noise due to a weak FM stereo
signal can be suppressed by setting FM ST./FM
to FM (mono). The stereo indicator disappears
from the display and you will hear the FM
programme in mono.
• Tune automatically, manually or by means of the
PRESETS buttons.
• Adjust the sound with VOLUME and DBB (bass).
• The set is switched off when ВАВЮЯАРЕ is in
position TAPE and no cassette player button is
pressed.