Philips COLOR TV - Manual (Page 22)

A djusting the PIP T int S etting the TV’ s C lock
'T^he Picture-In-Picture (PIP)
J. Tint control is used to make fine
tune adjustments to the tint setting
for PIP (when it is shown on the TV
screen).
( BEGIISI)
Press the MENU button on the
remote to show the onscreen menu.
<l> Press the CURSOR UP ► or
the CURSOR DOWN ■ button
until the word PIP is highlighted.
<|> Press the CURSOR RIGHT
button to display the PIP
TINT control.
<S> Press the CURSOR RIGHT
or the CURSOR LEFT
buttons to adjust the TINT bar to
the desired levels.
Press the STATUS/EXIT but­
ton to clear the menu from the
screen when the adjustment is com­
plete.
(0:
S mart H elp
Remember, although
^ there is a separate TINT
control for PIP, the adjustment lev­
els for this control depend on the
TV’s main picture. For example: If
the main picture screen is showing
a black and white picture, PIP
would also be seen in black and
white (even though the PIP picture
source is in color).
CLOCK
CC
► '
OFF
fpip ► 1
SETUP ►
SmartLock REVIEW ►
POWER 0
rTV RECORD
rUS/EX(T CC CLOCK
3 0 0
I---© ®
®
4
®
!^ iO ) ® A
m
a
SWAP SOURCE POSmON FREEZE
O O O O
o"
<T>
y our television comes with an
onscreen clock. During normal
operation the clock appears on the
screen when the STATUSIEXIT but­
ton is pressed or when a channel
change occurs.
C begin J
Press the CLOCK button on
the remote to display the onscreen
CLOCK menu.
<i> Press the CURSOR UP ► OR
CURSOR DOWN ■ buttons until
the words SET CLOCK are high­
lighted.
Enter the current time using
the NUMBERED buttons. If the
first number is a single digit first
enter a zero then the digit (i.e.,
press “0”, then press “8”).
<i> Press the CURSOR RIGHT
^ or CURSOR LEFT ^ but­
tons to set either AM or PM time.
Note: The CLOCK onscreen menu
can also be accessed through the
main menu by
pressing the MENU
button; then scrolling up/down
with the CURSOR UP ^ or
CURSOR DOWN ■ buttons
until
the word CLOCK is highlighted.
Press the CURSOR RIGHT ^
button
to activate the CLOCK
menu and follow the steps above to
set the time.
S mart H elp
Remember: Be sure to
i press “0” first and then the
hour number for single digit
entries.
To clear the onscreen menu press
the STATUS/EXIT button, or wait
a few seconds after you have fin­
ished your adjustment and the
menu will automatically disappear
from the screen.
40