Philips Magnavox AZ 7356 - Manual (Page 10)

CONNECTIONS
m
3
(Q.
to'
3
"
Connections for in-car use
1 Find a good and safe place
for the CD player on a
horizontal, vibration-free, and
stable surface that is not
dangerous or in the way of the
driver or passengers.
2 Connect the DC plug of the
voltage converter AY 3560
(6V/400 mA Direct Current, <$>
^>- ❖ plus-pole ❖ to the center pin,
only for a 12 V car battery, negative grounding) to the 6V DC jack of your CD player.
3 Then insert the voltage converter into the cigarette lighter jack. If necessary, clean
the cigarette lighter jack to obtain a good electrical contact.
4 Turn down the volume and switch off the auto reverse feature (if present) of
your car radio cassette piayer.
5 Connect the cassette adapter plug to the REMOTE Ci jack of the CD player.
6 Slide the cassette adapter carefully into the car radio cassette player.
7 Make sure that the cord cannot hinder your driving.
8 Start the CD player, turn its volume to middle position (approx, position 6-8) and
adjust the sound with the car radio controls.
• To remove the cassette adapter, press the eject button of the car radio.
• Always remove the voltage converter when the CD player is not in use.
Notes on In-car Use:
- Avoid excessive heat from the car heating or from direct sunshine (e.g., when
parking in the sun).
- if your car radio has a LINE IN jack, it is best to use it for the car radio connection
instead of the cassette adapter. Connect a signal lead (optional) to this LINE IN jack
and the REMOTEii jack of the CD player.
10