Philips AK 640 - Manual (Page 8)

OPERATION
5*
(Q
Playing the entire disc
• Press PLAY/PAUSE ►!! on the unit.
- Playback starts with the first track.
- The display shows the current track
number and its elapsed playing time.
- When all the tracks have been played,
the CD player stops and the total
number of tracks and total playing
time are shown on the display.
• To stop playback, press STOP ■ on the
unit.
• To interrupt playback, press PLAY/
PAUSE ►!! on the unit.
• To resume playback, press PLAY/PAUSE
►II on the unit again.
• Press POWER button to switch the unit
off.
Note:
Instead of pressing the OPEN/CLOSE button
after inserting the disc, you can also press
the PLAY ► button.
- The CD tray will close and start playback.
Interrupting play
• Press PLAY/PAUSE.
- The display shows
• Press PLAY/PAUSE again if you want to
resume playback.
- PRuSS goes out.
Stopping play
• Press STOP if you wish to stop play. The
total numberof tracks and the total playing
time will now appear in the display.
» Press OPEN/CLOSE to remove the CD.
Playing in a desired order (Program)
By programming the player, you can play up
to 32 tracks in any desired order. If you
exceed the maximum of 32 tracks, the letter
P (FULL) will appear in the display.
• Press PREVIOUS or NEXT briefly (less
than 0.5 second) to locate a particular
track.
• When you have found the correct track
number, press PROGRAM to store it in
the memory.
- The display will show 'P' and the total
playing time on the disc..
• Repeat this procedure to select other
tracks that you wish to programme into
the memory.
- If the unit is in Normal “PLAY”, “SHUF­
FLE”, and “INTROSCAN” modes,
you can programme thecurrenttracks.
• During playback, you can program atrack.
- Press SELECT + or SELECT - to
locate a particular track.
- Press PROGRAM when you recog­
nise a track which you wish to pro­
gramme into the memory
- The display shows P and the total
playing time on the disc.
Playing a program
• Press PLAY/PAUSE.
- "PROGR" appears on the display and
playback starts with the first track of
the program.
- When all tracks have been played, the
display shows the number of tracks
and the playing time of the disc now in
the play position.
Reviewing the program
• To review the tracks which you have
programmed, press REVIEW.
- The programmed tracks will be dis­
played. If no programme is available,
will be displayed.