GIN Gingo Airlite - Manual (Page 13)

13
CAUTION: Make sure that the speed system
is not too short. The front risers of your
paraglider must not be pulled down in normal
(unaccelerated) flight. Before you fly
Make sure your dealer has checked the harness for completeness and basic settings. Your
harness must be assembled by a suitably qualified paragliding professional, for example, your
instructor.
Gin Gliders recommends that assembly be carried out in the following order. If you are in any
doubt whatsoever about this procedure, please seek professional advice from your instructor, GIN
dealer or importer.
Installing the speed system
Assemble the speed system from top to bottom. Pass the cord along the inside of the harness
and route it through both pulleys (1). From the second pulley, route the cord through the metal ring
at the bottom edge of the seat (2). Connect the cord to the speedbar using a secure knot (3). Finish
by attaching the speedbars elastic cord (located next to the metal ring) to the speedbar. This allows
easy access to the speed bar and prevents tangling in case of a rescue deployment.
2 1
1
2
3
3
*See page 27 for speed system
adjustment