GIN Gingo Airlite - Manual (Page 17)

17
Installing the seat plate
The seat plate is removable and can be accessed by a panel at the rear of the seat. Simply
remove by separating the leg straps and pulling it out the back. When installing the seat plate be
sure to loop the leg straps over the back edge of the seat (covered in Velcro). The seat plate should
be installed with the Velcro edge to the back and the front curve facing down.
WARNING: Forgetting to loop the leg straps
behind the seat plate will place the pilot in
great risk of falling out of the harness.
*shown with optional carbon seat plate