Cleaning, Maintenance inspections, Maintenance inspections for certification – GIN Tribe User Manual

Page 18: Repairs

Advertising
background image

18

allow residual moisture to evaporate, and do not transport or store the glider in the proximity of

chemicals such as gasoline, paints or other solvents.

Cleaning

Use only lukewarm water and a soft cloth to clean your wing. Never use any abrasive materials or

detergents. Only clean the wing if it is absolutely necessary e.g. after a landing in salt water.

Maintenance Inspections

GIN Gliders require the Tribe to be inspected by an authorized Gin agent after every 100 hours
flying time or every year, whichever is sooner.
To extend the validity of the EN/LTF certification a full inspection is required every 200 hours or

every 24 months. This inspection should be made not only to the fabric, but also the lines. The
maintenance instructions, which can be downloaded from our homepage www.gingliders.com, have

to be observed.
A full inspection will give you peace of mind and extend your glider's lifetime. Additional inspections
should be performed by a qualified person following a crash or violent landing on the leading edge,

or if you note a deterioration of performance or behaviour.
You should also check for any damage to your lines, sail, risers and connectors before each flight.

Maintenance Inspections for Certification

As mentioned, the Tribe requires regular inspections. Without these inspections, the EN/LTF
certification will be invalid. Please check with an authorized agency or a specialist about flight time

and regular inspections.

Repairs

Very small holes in the sail can be repaired with the sticky back tape provided with your glider.

Damaged lines should be replaced by your GIN dealer. Before fitting a replacement line, check it for
length against its counterpart on the other side of the wing. When a line has been replaced, always

inflate the glider on flat ground to check that everything is in order before flying.
Major repairs, such as replacing panels, should only be carried out by the distributor or
manufacturer.

Environmentally friendly disposal of the paraglider

When this paraglider cannot be used any longer after an extended period of life time, then you must

ensure that it will be disposed of in an environmentally friendly way. Please observe the existing

regulations and laws in your country.

Advertising