GMC 2006 Canyon - Manual (Page 61)

3. Tighten the lower anchor attachments and the top
tether. The child restraint instructions will show
you how.
4. Push and pull the child restraint in different
directions to be sure it is secure.
Front Seat — Regular/Extended Cab
without Rear Seats
Your vehicle has a right front passenger’s airbag and a
passenger sensing system. The passenger sensing
system is designed to turn off the right front passenger’s
frontal airbag when an infant in a rear-facing infant
seat or a small child in a forward-facing child restraint or
booster seat is detected. See Securing a Child
Restraint in the Right Front Seat Position on page 1-59
and Passenger Sensing System on page 1-72 for
important safety information and additional information
on installing a child restraint in the right front seat
position.
1. See Securing a Child Restraint in the Right Front
Seat Position on page 1-59 for instructions on
installing the child restraint using the safety belts.
2. If the child restraint manufacturer’s instructions
recommends that the top tether be attached,
attach and tighten the top tether to the top tether
anchor. Refer to the child restraint instructions and
the following steps:
2.1. Pull the seatback forward to access the top
tether anchor. See Seatback Latches on
page 1-9.
2.2. Pull on the finger access tab to remove the
cover to access the top tether anchor.
2.3. Route the top tether according to your child
restraint instructions and the following
instructions:
If the position you are
using has a fixed head
restraint and you are using
a single tether, route the
tether over the head
restraint.
1-55