GME MT410AUS - Manual (Page 6)

Location for deployment
The MT410/410G will deliver best performance where
there is a clear view of the sky. Deploying the beacon
within an enclosure, particularly one which is electrically
conductive such as under a car roof, will reduce the signal
strength and may mean that it cannot be detected by
rescue satellites or overflying aircraft. If you find yourself
in a narrow valley or ravine, you can greatly increase the
chances of your beacon signal being detected by placing it
on higher ground.
Deploy the beacon in an upright position with the wire
antenna vertical and well clear of any surrounding
obstructions such as trees or rocks.
If adverse weather conditions exist, use any available
props around the base of the beacon to ensure it will not
topple over. Where on-person operation is unavoidable,
choose an elevated position that also achieves good local
clearance around the vertical wire antenna.
Once the beacon has been activated, leave it switched on.
A continuous signal is needed for Rescue Authorities to
determine your location.
ACTIVATING THE MT410/410G
1. Hold firmly and release the antenna by pushing the
black arm (where marked by a yellow triangle) inwards
then upwards The antenna will quickly uncoil and
extend.
2. Swing the antenna fully upwards 180 degrees
clockwise, breaking the safety seal. The antenna
arm will click into place.
The PLB is now active.
The MT410 will ‘beep’ and pulse the inbuilt light 20-21
times per minute. The MT410G will emit a rapid series
of ‘beeps’ and light flashes for a period of 6 seconds,
indicating to the user that it has acquired a GPS position
fix and is relaying this position along with the distress
signal and the unique personal identifier to the COSPAS-
SARSAT satellite system.
After 6 seconds the MT410G will continue to ‘beep’ and
pulse the light 20-21 times per minute.
PA G E 6 I N S T R U C T I O N M A N UA L 4 0 6 M H Z P L B
43003-11_MT410&GinsMan.indd 6 26/08/13 3:59 PM