Cobra Electronics 75 WX ST - Manual (Page 5)

INSTALLATION
CONNECTOR BOX
9
INSTALLATION
CONNECTOR BOX
8
MOUNTING
CONNECTOR BOX
1. Hold Cobra 75 WX ST
Connector Box in exact
location desired for
mounting.
2. Using it as a template,
mark the location for
the mounting screws
(included).
NOTE: Make certain that
nothing will interfere with
the installation of the
mounting screws, before
drilling holes.
3. Mount Connector Box
as shown.
CONNECTING WIRES
1. Connect the antenna
cable connector.
2. Connect the red wire
marked “BATT” (+)
directly to the positive
side of the battery or to a
connection on the fuse
box that is always on.
3. Connect the black wire
marked “Ground” (-) to
the negative side of the
car, usually the chassis.
Any other location with
good electrical contact
(paint removed) will
also work.
CAUTION: Leaving the 75 WX ST on after your car is turned off can
drain your car battery when connected to a constant 12
volt source. When connected to accessory 12 volt source
unit will turn off.