Great Planes Bench Topper - GPMR8500 - Manual

B
ENCH
T
OPPER
Workbench Organizer
Thank you for purchasing the Great Planes ® BenchTopper
workbench organizer. In our busy workshop at Great Planes
we find it necessary to keep our bench tops well organized
and our tools readily accessible. Once we thought of the
idea for the BenchTopper and made the first prototype,
everybody in the shop wanted one! Now you can keep your
work area neat and organized too – you may even find that
you build your models a little faster since it’ll be easier to find
all of your tools!
We’ve provided assembly instructions for the BenchTopper
and left the finishing up to you. You can build your
BenchTopper with no protective finish or go all out and paint
your BenchTopper your favorite color. If you choose to build
your BenchTopper without a finish and leave it bare wood,
then all you have to do is follow the instructions provided. If
you choose to add a finish to your BenchTopper, you'll have to
do a little planning ahead and think about parts that might be
easier to sand and/or paint before they are glued together. In
any case, we recommend sanding all the pieces before you
do any gluing. If you choose to paint your BenchTopper, at
least one coat of primer is recommended to fill the wood grain.
Pactra
® Prep or a similar brush-on primer yields good results.
Any kind of glue that works on wood will work for your
BenchTopper. We built our prototypes with thin CA and CA
accelerator by first “priming” the glue joint with CA accelera-
tor, then applying a few drops of thin CA to the “pre-primed”
joint. The CA will cure immediately before it has had a
chance to soak too far into the wood away from the glue
joint. Should you choose to use medium or thick CA, refrain
from making large fillets that are unnecessary and will
detract from the overall appearance of your BenchTopper.
Refer to the die-cut parts layout on page 4 to familiarize
yourself with what each part looks like. As you separate the
pieces from the sheets, lightly sand the edges. This will
improve glue adhesion.
Please inspect all parts carefully before starting to build! If
any parts are missing, broken or defective, or if you have
any questions about building this workbench organizer,
please call us at (217) 398-8970. If you are calling for
replacement parts, please reference the part numbers (see
the back cover) and the kit identification number (stamped
on the end of the carton) and have them ready when calling.
❏
We recommend Great Planes Pro ™ Thin CA
(GPMR6002) and Accelerator (GPMR6035).
❏
Sanding block and assorted sandpaper.
❏
Razor saw.
❏
Hobby knife.
❏
Wood filler.
❏
Paint.
❏
Join A and B to C, then add D. Glue together.
❏
Fit E and F to G, then join to C. Note: The notch in F goes
toward the rear. Glue the assembly together.
❏
Fit, then glue the back H to the assembly.
Main Assembly
Optional Supplies
Tools & Supplies
™