Great Planes Super Sportster EP RxR - GPMA6006 - Manual (Page 5)

5
BUILDING INSTRUCTIONS
❏
1. If you have not done so already, remove the major
parts of the kit from the box and inspect for damage. If any
parts are damaged or missing, contact Product Support at
the address or telephone number listed in the “Kit Inspection”
section on page 4.
❏
2. Insert the square elevator joiner into the pocket of one
of the horizontal stabilizer halves, being sure that the joiner
is fully seated in the pocket.
❏
3. Slide the two horizontal stabilizer halves into the fuselage
so that the carbon pins installed in one side fi t into the mating
holes in the other side and that the elevator joiner fi ts into
the other joiner pocket. Align the four holes in the molded
plastic stab saddle with the holes in the plywood plates on
the underside of the stab halves. Secure the stab halves to
the stab saddle using four 2x6mm screws.
❏
4. Connect the elevator pushrod to the outer hole of the
elevator control horn and secure it using the 90 degree pushrod
connector that is attached to the pushrod.
❏
5. Insert the carbon wing tube into one of the wing panels.
Slide the other panel onto the tube, being sure that the
aileron servo leads are aligned with the grooves at the
roots of the wings.