Great Planes Super Sportster EP RxR - GPMA6006 - Manual (Page 6)

6
❏
6. Connect the included Y-harness to the aileron servo leads.
Install the wing onto the fuselage using the nylon wing bolt.
❏
7. Press the landing gear wires into the plastic landing
gear blocks as shown. Be sure that the landing gear is fully
seated in the blocks.
❏
8. Use a piece from the included double-sided foam tape
to attach your receiver to the side of the fuselage as shown.
Connect the elevator servo, rudder servo, aileron servos and
ESC to the receiver. If you have installed a 2.4GHz receiver,
tape the receiver antennas to the side of the fuselage in the
orientation described in your radio manual. An FM receiver
antenna should be routed out the cool air exit hole on the
underside of the fuselage and taped to the underside of the fuse.