Great Planes Extra 300S 60 Kit - GPMA0236 - Manual (Page 24)

❏
9. Glue the rest of the fuse sides to the fuse top.
❏
10. Glue former 8 (part #8) in place.
❏
11. Glue former 9 (part #9) and former 10 (part #10)
in place.
❏
12. Glue the fuse bottom (part #4) in place. Note:
Former 9 extends through the fuse bottom. This will be used
as a guide for the bottom stringers later in the manual.
❏
13. Glue former 11 (part #11) in place.
❏
14. Sand the 1/4" x 1-1/4" x 5-1/2" birch ply wing bolt
block to fit precisely in the slots in the fuse doublers. Note:
It is very important that the fit of the wing bolt block
be precise.
❏
15. When satisfied with the fit of the wing bolt block,
glue it in place with 30-minute epoxy.
❏
1. Sand the entire wing saddle area lightly until the fuse
side doublers and fuse sides are flush.
❏
2. Test fit the wing on the fuse. If the wing is slightly too
large (front to rear) to fit into the saddle, sand the TE of the
wing slightly until it fits.
❏
3. Laminate two pairs of the die-cut 1/16" wing dowel
disks together with 6-minute epoxy. Drill 1/4" holes through
the punch marks at the center of each of the laminated disks.
Mount the Wing to the Fuselage
24