Great Planes Edge 540 3D Indoor EP ARF - GPMA1128 - Manual (Page 10)

10
❏
4. Center the servo arm on the elevator servo and trim off
the three extra arms. Use foam-safe CA to glue the elevator
servo to the elevator servo offset.
❏
5. Install the pre-assembled elevator pushrod by inserting
the pushrod guides through the fuselage as shown. DO NOT
glue the pushrod guides in place at this time.
❏
6. Remove the elevator servo arm and insert the z-bend
into the outer hole of the arm. Note: If you are not using a
computer radio, and do not wish to set your model up with
3D control throws, you will need to insert the z-bend in a hole
closer to the servo. The z-bend should be installed so that the
pushrod is on the back side of the servo arm, closest to the
fuselage. Center the servo and reinstall the servo arm onto
the servo, securing it with the servo screw.
❏
7. Insert the z-bend in the elevator control horn. Insert the
control horn in the slot in the elevator. The notch in the control
horn should slide over the carbon fi ber strip in the elevator.
If the control horn will not fi t over the carbon fi ber strip, use
a sharp hobby knife to remove the excess glue from the slot.
DO NOT glue the horn in yet.
❏
8. Insert the rudder pushrod , from the front, through the
fi ve pushrod guides. The z-bend should be next to the rudder
servo arm. Remove the servo arm from the rudder servo and
insert the z-bend in the servo arm so that it is on the outside
of the arm, away from the fuselage. Re-install the servo arm
screw in the servo.