Great Planes Edge 540 3D Indoor EP ARF - GPMA1128 - Manual (Page 8)

8
❏
16. Check that all the carbon rods and brace doublers are
in position and straight and the crutches are in position and
fl at on the building table. Start by gluing the carbon rod and
long brace doublers to the wing at the wing tips.
❏
17. Next check that everything is still straight and glue the
carbon rod to the landing gear support.
❏
18. Position the short brace doublers so that both carbon
rods pass through the brace doubler on each side. Glue the
brace doubler and carbon rods to the vertical fuselage.
❏
19. Once the glue has cured, glue the carbon rods to the
brace supports.
❏
20. Remove the motor mount and glue the upper motor
doubler to the front of the vertical fuselage. The front of
the upper motor doubler should be fl ush with the front of
the fuselage.
❏
21. Use a sharp hobby knife to carefully cut the #1 and #3
top crutches from the bottom crutches.