Great Planes PT-E Trainer Electric Kit - GPMA0110 - Manual (Page 33)

D 4. 1/2" strips of covering at joint between bottom of
stab and fuse.
D 5. 1/2" strips at joint between stab and fin.
D 7. Use a pin to poke "vent holes" in the bottom rear
corners of the stab to allow air to escape when cover-
ing the top. (Also do this before shrinking the fin,
rudder and wing covering).
D 8. Stab top
D 6. Stab bottom
D 9. Shrink the stab covering, top and bottom
D 10. Fin left side and T.E.
D 11. Fin right side (overlap around T.E.)
D 12. Shrink fin covering, both sides
D 13. Hold rudder against fin and mark hinge locations
on fin. Slit covering at slots.
D 14. Rudder left side and L.E.
D 15. Rudder right side (overlap around L.E.)
D 16. Shrink rudder covering, both sides
D 17. Slit covering at rudder hinge locations
D 18. Hatch bottom
D 19. Fuse bottom
33