Great Planes PT-E Trainer Electric Kit - GPMA0110 - Manual (Page 34)

COVER THE WING
D 20. Fuse sides
D 21. Fuse top behind wing
D 26. Wing tips
D 22. 1/2" strip at base of windshield
D 23. Windshield
D 24. Fuse top in front of windshield
25. Iron the covering down around all openings that
are to be cut out, then use a sharp Xacto knife to
carefully cut the covering from the following open-
ings: Pushrod exit slots, Wing hold-down dowel holes,
Toggle switch hole. Landing gear plate air exit holes,
Landing gear mounting screw holes, Micro switch
mounting screw holes, Elevator and rudder control
horn mounting screw holes, and the Radio switch
and switch mounting screw holes. D
D 27. Wing bottom left (overlap centerline 1/4")
D 28. Wing bottom right (overlap covering 1/2")
D 29. Wing top left (overlap centerline 1/2" and iron
covering to the side of rib W-l
D 30. Shrink covering on left wing panel, top and bot-
tom
D 31. Wing top right (overlap covering 1/4")
34