Great Planes Spirit 100 ARF - GPMA1049 - Manual (Page 14)

❏
10. Attach the Z-bend end of the spoiler activation rod to
the spoiler servo.
❏
1. Attach the switch, charge jack, servos and servo
extensions to the receiver. Wrap the receiver in foam.
❏
2. Push the receiver into the bottom of the fuse and retain
it with a small piece of Velcro ® .
❏
3. Drill a 1/16" [1.6mm] hole through the fuse side for the
antenna. Take a cut-off piece of servo arm with at least two
holes in it, and feed the antenna through two of the holes,
making a strain relief which protects the antenna from
accidentally being torn out of the receiver. Position the strain
relief so that there is a small amount of slack between the
receiver and the when the strain relief is positioned against
the inside of the fuse.
❏
4. Mount your switch in the canopy area with silicone glue,
making sure it does not interfere with the pushrods or canopy.
❏
1. Wrap the receiver battery in foam and tape. Tape the
battery to the outside of the fuse. NOTE: The battery will be
installed after the CG is set.
Set the C.G.
Final Radio Installation
14