Great Planes Spirit Elite ARF MonoKote - GPMA1047 - Manual (Page 13)

❏
10. Insert the elevator pushrod (the one with the modified
horn) through the back of the fuselage, into the guide tube
and to the elevator servo.
❏
11. Position the control horn so the clevis holes are
centered over the hinge line. Mark the two mounting holes
onto the elevator. Drill two 1/16" [1.5mm] holes at the marks.
Hint: To strengthen the holes, place one small drop of CA
into each hole and redrill.
❏
12. Attach the control horn to the elevator and rudder
using two 2-56 x 3/8" [9mm] screws along with the backplate.
❏
13. Install the rudder pushrod.
❏
14. Temporarily, plug the elevator and rudder servos into
the receiver and turn on the transmitter and receiver. Center
the sticks and the trims.
❏
15. With the elevator held at center, mark the pushrod
where it crosses the servo arm.
Align the Control
Horn on the
Rudder at an Angle
Front
13