Great Planes Spirit Elite ARF MonoKote - GPMA1047 - Manual (Page 9)

❏
5. Install the wing onto the wing saddle. Line up the
center line of the wing with the center line of the fuselage
and drill a 5/32" [4mm] hole at the marks. Drill completely
through the wing and wing bolt plates inside the fuselage.
❏
6. Remove the wing and enlarge the holes in the fuselage
to 7/32" [5.5mm].
❏
7. Install the two 8-32 blind nuts into the fuselage. Use the
8-32 Cap screw with a washer to “pull” them into the wood.
❏
8. Trial fit the wing onto the saddle. Secure the wing in
place using the two 8-32 Cap screws with washers.
❏
1. Measure and mark the center of the trailing edge of
the stab.
❏
2. Place the stab onto the mount and clamp the trailing
edge so it is centered on the fuselage.
❏
3. Measure from the wing tip to the stab tip on both sides.
Being careful to keep the trailing edge centered, adjust the
front of the stab left or right until properly aligned.
❏
4. Mark the underside of the stab on each side of the
stab saddle.
A A
A = A
Install the Stabilizer (Stab)
9