Great Planes Super Stearman EP ARF - GPMA1150 - Manual (Page 9)

9
❏
2. Temporarily bolt the wing to the fuselage with two 4-40
x 1" [25mm] bolts and #4 fl at washers.
❏
3. Slide the wire elevator joiner into the stab opening
❏
4. Slide the stab into the stab opening making sure the
wire stays in the opening.
❏
5. Make sure the stab aligns with the wing. If it does not,
lightly sand the stab saddle.
❏
6. Temporarily install the rudder into the opening in the stab.
❏
7. Measure the distance from the tips of the stab to the tips
of the wing. Adjust the stab until they are equal.
❏
8. Carefully remove the fi n and rudder, making sure you
do not disturb the stab. Wick CA glue into the joint, securing
the stab to the fuselage. Allow the glue to cure.