Heli-Max HMXE04 Addendum - Manual

SPINDLE AND BOL SPINDLE AND BOL T T
REPLA REPLA CEMENT PR CEMENT PR OCEDURE OCEDURE
Included:
(1) Spindle
Required Tools: (2) 2mm x 6mm Socket Head Cap Screws
(2) #1 Phillips Screwdrivers (2) 2mm x 5mm Flat Washers
(1) 1.5mm Allen Wrench (from original kit) (1) 1.5mm Allen Wrench
1. Before starting, make note of the 2mm nut used on the bottom of each blade grip. When removing the blade bolt, press upward on the
nut to ensure it remains in the grip. Remove the blade grip bolts using the 1.5mm allen wrench, then remove the blades from the helicopter.
2. Please be very cautious with this next step. You must have a
firm grip on the Phillips screwdrivers and blade grips (to prevent
the head from rotating) while trying to loosen the Phillips
spindle bolts. 3. With a firm hold on the blade grip and the two Phillips
screwdrivers, partially remove one of the spindle bolts. Using
the Phillips screwdriver, push inward on the partially loosened
spindle bolt until it touches the blade grip bearing. If the spindle
does not slide to the other side, use a small hammer and lightly
tap the end of the screwdriver. Finish unthreading the partially
loosened spindle screw and remove it from the spindle.