One-touch turn signal, Wiper operation, One-touch turn signal wiper operation – HONDA 2015 CR-V - Owner's Guide (Revised 01/07/2014) User Manual
Page 24: P. 41
40 |
| 41
VEHICLE CONTROLS
VEHICLE CONTROLS
Exterior Lights
rotate the switches on the headlight lever to operate the exterior lights. Push the
lever forward to turn on the high beams. Return the lever to its original position for
low beams.
OFF: All exterior lights are off.
: Turn on exterior lights except headlights.
AUTO: Turn on the automatic lighting feature*.
Headlights turn on or off depending on ambient
brightness when the vehicle is on. Headlights
automatically come on after the wipers are
engaged for a certain time.
: Turn on all exterior lights including headlights.
: Turn fog lights* on or off.
*if equipped
High beams
Low
beams
Flashing the
high beams
Fog lights*
One-Touch Turn Signal
Use this quick and convenient method to signal a lane change.
Lightly push the turn signal lever up or down for a
three-blink sequence.
For a continuous signal, push the lever up or down
until it locks into place.
Left turn
right turn
Wiper Operation
The windshield wipers and washers can be used when the vehicle is on.
Front Wipers
Move the wiper lever up or down to the desired
position.
Headlight-Wiper Integration*
When the headlights are in the AUTo position,
they automatically turn on when the front
wipers operate several times within a certain
interval. The headlights turn off shortly after
the wipers are turned off, or if there is enough
ambient light.
Intermittent or Automatic Wipers*
When you move the lever to the INT or AUTO
position, the wipers operate based on the wiper
delay.
Adjust the wiper delay using the adjustment ring.
Rear Wiper
When you shift to reverse (r) and the front
wipers are activated, the rear wiper activates
even if the switch is off.
1
INT: Intermittent
2
ON: Continuous wipe
3
OFF
4
Washer
4
2
1
3
4
Do not use the wipers when the windshield is dry. The windshield will get
scratched, or the rubber blades will get damaged.
In cold weather, the blades may freeze to the windshield, becoming stuck.
operating the wipers in this condition may damage the wipers. Use the defroster
or heated windshield button* to warm the windshield, or manually clear the
windshield of ice and snow before turning on the wipers.
NOTICE
*if equipped
Intermittent time
adjustment ring
Pull to use
washer.
1
MIST
2
OFF
3
INT*: Low speed intermittent
AUTO*: Automatic intermittent
4
LO: Low speed wipe
5
HI: High speed wipe
1
2
3
4
5