Changing a flat tire, Warning – HONDA 2015 CR-V - Owner's Guide (Revised 01/07/2014) User Manual

Page 62

Advertising
background image

116    |

| 117

HANDLING THE UNEXPECTED

HANDLING THE UNEXPECTED

TABLE OF CONTENTS

INDEX

VISUAL INDEX

VOICE COMMAND

INDEX

SAFETY

INFORMA

TION

CUSTOMER

INFORMA

TION

INSTRUMENT P

ANEL

SPECIFICA

TIONS

VEHICLE

CONTROLS

MAINTENANCE

AUDIO AND

CONNECTIVITY

HANDLING THE

UNEXPECTED

BLUETOOTH

®

HANDSFREELINK®

DRIVING

HONDALINK™

NA
VIGA

TION

Changing a Flat Tire

If a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually 

to reduce speed. Then, stop in a safe place. replace the flat tire with the compact

spare tire. Go to a dealer as soon as possible to have the full-size tire repaired or 

replaced.

Getting Ready to Change the Tire

Park the vehicle on a firm, level, non-slippery surface. Apply the parking brake, 

shift to Park (P), and turn the vehicle off. Turn on the hazard warning lights.

1. open the tailgate. Turn on the cargo lights if

necessary (see page 39).

2. open the cargo area floor lid.

3. Take the tool bag out of the cargo area. Take the 

jack handle bar and wheel nut wrench out of the 

tool bag.

4. Take the jack out of the spare tire area.

5. Unscrew the wing bolt and remove the spacer 

cone. Then remove the spare tire.

6.  Place a wheel block or rock in front and rear of 

the wheel diagonal to the flat tire.

7. Place the compact spare tire (wheel side up)

under the vehicle body, near the tire that needs 

to be replaced.

8. Loosen each wheel nut about one turn using the 

wheel nut wrench.

Tool bag

Spare tire

Setting Up the Jack

1. Place the jack under the jacking point closest to

the tire to be changed.

2. Turn the end bracket clockwise (as shown in 

the image) until the top of the jack contacts the

jacking point. Make sure that the jacking point

tab is resting in the jack notch.

3. Raise the vehicle, using the jack handle bar and 

the jack handle, until the tire is off the ground.

The following instructions must be followed to use the jack safely:

•  Do not use the jack with people or luggage in the vehicle.
•  Use the jack provided in your vehicle. other jacks may not support the weight

(“load”) or fit the jacking point.

•  Do not use while the engine is running.
•  Use only where the ground is firm and level.
•  Use only at the jacking points.
•  Do not get in the vehicle while using the jack.
•  Do not put anything on top of or underneath the jack.

Jack

handle

bar

Wheel nut

Wrench as jack handle

The vehicle can easily roll off the jack, seriously injuring anyone underneath.
Follow the directions for changing a tire exactly, and never get under the

vehicle when it is supported only by the jack.

WARNING

Advertising