HONDA 2012 Insight - Owner's Manual - Manual (Page 332)

Open the hood.
To change the bulb on the right
side, remove the upper part of the
windshield washer reservoir tank.
Use a flat-tip screwdriver to
remove the holding clip, then
remove the upper part by pulling it
straight up. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Install the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Turn on the lights to make sure
the new bulb is working.
Install the upper part of the
windshield washer reservoir tank
in the reverse order of removal.
(Right side)
6.
1. 2.
3.
4.
5.
Lights
Replacing a Front Parking Light
Bulb
326
BULB HOLDING CLIP
SOCKET