HONDA 2006 Civic Sedan - Owner's Manual - Manual (Page 202)

If you replaced a headlight bulb on
the driver’s side, reinstall the
engine coolant reserve tank.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Remove the electrical connector
from the socket by pushing on the
tab and pulling the connector
down.
Insert the socket into the hole, and
turn it one-quarter turn clockwise
to lock it in place.
Push the electrical connector back
onto the new socket. Make sure it
is on all the way.
Turn on the headlights to test the
new socket.
To change the bulb on the driver’s
side, start the engine, turn the
steering wheel all the way to the
right, and turn off the engine. To
change the bulb on the passenger’s
side, turn the steering wheel to the
left.
Use a flat-tipped screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
2.
3.
2.
4.
5.
6.
7.
1.
CONTINUED
Lights
Low Beam Headlight
Ma
int
e
na
nce
201
TAB
HOLDING CLIP
SOCKET
Main Menu Table of Contents