HONDA 2006 Civic Hybrid - Owner's Manual - Manual (Page 198)

To thoroughly flush the
transmission, the technician
should drain and refill it with
Honda CVT fluid, then drive the
vehicle for a short distance. Do
this three times. Then drain and
refill the transmission a final time.
Insert the dipstick all the way back
into the transmission securely.
The transmission should be drained
and refilled with new fluid when this
service is indicated by a maintenance
message on the information display.
If you are not sure how to add fluid,
contact your dealer.
Brake fluid marked DOT 5 is not
compatible with your vehicle’s
braking system and can cause
extensive damage.
Using any non-Honda brake fluid can
cause corrosion and decrease the life
of the system. Have the brake
system flushed and refilled with
Honda Heavy Duty Brake Fluid
DOT 3 as soon as possible.
Always use Honda Heavy Duty
Brake Fluid DOT 3. If it is not
available, you should use only DOT 3
or DOT 4 fluid, from a sealed
container, as a temporary
replacement.
Replace the brake fluid according to
the time recommendations in the
maintenance minder schedule.
Check the brake fluid level in the
reservoirs monthly.
Check the fluid level several seconds
after you turn the ignition switch to
the ON (II) position. The fluid level
should be between the MIN and
MAX marks on the side of the
reservoir. If the level is at or below
the MIN mark, your brake system
needs attention. Have the brake
system inspected for leaks or worn
brake pads.
6.
Transmission Fluid, Brake Fluid
Brake System
196
MAX
MIN
Main Menu Table of Contents