Indicator lights – HONDA 2003 Element - Owner's Manual User Manual
Page 72
This indicator comes on for a few
seconds when you turn the ignition
switch ON (II). It will then go off if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink
and the engine will not start (see
page
).
This indicator also blinks several
times when you turn the ignition
switch from ON (II) to ACCESSORY
(I) or LOCK (0).
The left or right turn signal light
blinks when you signal a lane change
or turn. If the light does not blink or
blinks rapidly, it usually means one
of the turn signal bulbs is burned out
(see page
). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signaling.
When you turn on the Hazard
Warning switch, both turn signal
lights blink. All turn signals on the
outside of the vehicle should flash.
This light normally comes on for a
few seconds when you turn the
ignition switch ON (II), and when
the ignition switch is turned to
START (III). If this light comes on at
any other time, there is a problem in
the ABS. If this happens, take the
vehicle to your dealer to have it
checked. With the light on, your
vehicle still has normal braking
ability but no anti-lock. For complete
information, see page
.
Only on models equipped with ABS (see
page
Immobilizer System
Indicator
Turn Signal and Hazard Warning
Indicators
Anti-lock Brake
System (ABS)
Indicator
Indicator Lights
Instruments and Controls
68
Main Menu
Table of Contents