IC Realtime 1.3Mp HD Cost-effective Network IR PTZ Dome Camera (ICIPM2008IR) - Manual (Page 11)

I C R E A L T I M E S E C U R I T Y S O L U T I O N S
8
2.b Step by Step Guide
 Step 1: Install wall mount bracket
Begin by first assuring that the wall you are mounting it on can support the bolts you will be using to hold the
mount. Assure the wall can sustain the weight of the PTZ by up to four (4) times its weight. Draw installation
holes accordingly and assure placement is even. Drill a large enough hole in the center so to pass the camera's
cabling through to the other side. Use bolts to now drill through the wall and fasten tightly.
 Step 2: Tunnel cables through bracket
Assure that the bracket you mounted is completely fastened and can sustain heavy weight. While holding the
PTZ close to the bracket, pass the camera's attached cabling through the bracket and assure it passes through to
the other side of the wall.
 Step 3: Mount PTZ
Loosen the M6 inner hex screw from the bracket. Align the PTZ with the wall bracket and assure that it fits
through the 'quick installation port'. Turn the PTZ so it rests in the grove. Tighten the M6 inn hex screw until
fully fastened and secure.
 Step 4: Attach safety cable
Lastly, securely attach the safety cable if not already on the PTZ. Clip the other end to the wall bracket. You will
notice a small loop hole attached on the under belly of the bracket.