ILY DUO / DUO PLUS Blu-ray/DVD/CD Duplicator - Manual (Page 8)

Note: The verification process uses a Disc Readability Check to individually check the presence of data on each copy. This process
does not compare the contents of duplicated discs against that of the master. It only verifies that the duplicated discs are readable.
To start the Copy + Verify process:
1). Power on the machine (if not already on).
2). Eject disc tray of the Source Drive and place the master disc in the designated Source Drive
(usually the top drive). The “master disc” is the original of which copies are made from.
3). Eject disc tray(s) of the Writer Drives and place blank disc(s) on the tray(s). Number of drives
used depends on number of copies desired. It is not necessary to always use all drives.
4). Use the scroll buttons to select the com mand “3. Copy + Verify” and press the ENT button.
The drives will automatically close trays and begin the copy process.
5). Once the copy process is completed, the tray(s) will open briefly, and then automatically close
again to begin the verify process.
6). Once the verify process is completed, the trays will automatically eject discs that have passed the
Copy + Verify process.
‘
4. Copy + Compare – This command will perform the copy process, and immediately follows with a
comparison between the master disc and the copied disc(s) to ensure the copies are exact duplicates of
the master disc. This command is especially useful for BDs, DVDs, data CDs and video CDs.
Note: The Compare process is a bit-by-bit comparison between the master disc and the copied discs. This operation ensures that all
of the copies are completely identical to the Master disc. This command is not applicable to audio CDs.
To start the Copy + Compare process:
1). Power on the machine (if not already on).
2). Eject disc tray of the Source Drive and place the master disc in the designated Source Drive
(usually the top drive). The “master disc” is the original of which copies are made from.
3). Eject disc tray(s) of the Writer Drives and place blank disc(s) on the tray(s). Number of drives
used depends on number of copies desired. It is not necessary to always use all drives.
4). Use the scroll buttons to se lect the “4. Copy + Compare” command and press the ENT
button. The drives will automatically close trays and begin the copy process.
5). Once the copy process is complete, the tray(s) will open briefly, and then automatically close
again to begin the compare process.
6). Once the compare process is completed, the trays will automatically eject discs that have
passed the Copy + Compare process.
 Press “ENT”
 Start Copy
 Start Verify
 Press “ENT”

 Copy
Completed

6