Interlogix MCR200-1T/1CX - Manual (Page 16)

10 IFS MCR200-1T/1CX User Manual
Connecting the MCR200-1T/1CX
Connecting to a Standalone IP device
Refer to the following procedures to setup the MCR200-
1T/1CX to a standalone PC.
1. Set the MCR200-1T/1CX to be CO or CPE mode from the
DIP switch at the rear panel.
2. Turn power on the MCR200-1T/1CX by connecting its
power source.
3. The power LED will illuminate.
4. Connect the coaxial cable from another MCR200-1T/1CX
to the BNC port of the MCR200-1T/1CX.
5. The LNK LED will blink.
6. Connect the Ethernet port to an Ethernet device via regular
Cat. 5, 5e, or 6 cables.
Figure 4: Connecting Standalone IP devices
Connecting Multiple Ethernet Devices to an Ethernet LAN
Refer to the following procedures to setup the MCR200-
1T/1CX to an Ethernet LAN.
1. Set the MCR200-1T/1CX to CO or CPE mode by using the
DIP switch at the rear panel.