Converter top panel, Wiring the power inputs, Converter top panel 7 – Interlogix MC250-1T/1S User Manual
Page 11: Wiring the power inputs 7
Advertising
IFS MC250-1T/1S User Manual 7
Converter Top Panel
The top panel of the MC250-1T/1S consists of a terminal block
connector with two DC power inputs.
Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of the
MC250-1T/1S is used for two DC redundant powers inputs.
Please follow the steps below to insert the power wires.
1. Insert positive / negative DC power wires into the contacts
1 and 2 for POWER 1, or 5 and 6 for POWER 2.
V1- V1+ V2- V2+
2. Tighten the wire-clamp screws to prevent the wires from
disconnecting.
Advertising