Interlogix NS3500-28T-4S Quick Start - Manual (Page 9)

9
5. Repeat Step 1 to check if the IP address is changed.
If the IP is successfully configured, the Managed Switch will apply the new IP address setting
immediately. You can access the Web interface of Managed Switch through the new IP address.
Note:
If you are not familiar with console command or the related
parameter, enter “?” anytime in console to get the help description.
6. Saving the Configuration via the Console
In switch, the running configuration file stores in the RAM. In the current version, the running
configuration sequence running-config can be saved from the RAM to FLASH by write command or
copy running-config startup-config
command, so that the running configuration sequence
becomes the start up configuration file, which is called configuration save.
1. On “NS3500-28T-4S#” prompt, enter “copy running-config startup-config” as shown in Figure
6-1.
Figure 6-1:
Saving the Configuration Screen