Interlogix MS-PoE - Manual (Page 15)

Chapter 2: Hardware Installation
Figure 2: Connection to the IEEE 802.3af device
1. Switch
2. Power
3. Camera
4. Data
100 Base-TX UTP
100 Base-TX UTP with PoE
Once MS-PoE detects the existence of an IEEE 802.3af device, the LED
indicator will stay steady ON to show it is providing power.
Note: If the connected device does not fully comply with the IEEE
802.3af standard or in-line power device, the LED indicator of MS-PoE
will not be steady on.
Installing an MS-PoE and a SP-POE, Injector and
Splitter
1. Connect a standard network cable from "Ethernet+DC" of MS-PoE to
"Ethernet+DC" of SP-POE. The POE LED of MS-PoE / SP-POE will
light up continually.
2. Connect the UTP cable in the package from "Ethernet" of SP-POE to
the RJ-45 port of the remote device.
3. Connect the correct DC plug from "DC OUT" of SP-POE to the
remote device.
MS-PoE Injector User Manual 9