Interlogix TR3000 Series - Manual (Page 7)

Product Disassembly Instructions for WEEE
Per European Directive 2002/95/EC Waste Electrical
and Electronic Equipment
Required Tools:
One number 2 Phillips (crosstip) screwdriver.
One number 2 flat screwdriver.
For the enclosed box version:
1. Locate and remove box cover securement screws.
Usually, but not limited to at least 4 screws.
2. Lift off box top cover.
3. Locate and remove securement screws for printed circuit board.
4. If there are multiple boards to the assembly, continue removing
securement screws until none are left.
5. Lift off printed circuit board(s).
6. Disassembly of box version of product is complete.
For the rack version:
1. Locate and remove box cover securement screws
for printed circuit board. Usually, but not limited to at least 4 screws.
2. If there are multiple boards to the assembly, continue removing
securement screws until none are left.
3. Lift off printed circuit board(s).
4. Disassembly of box version of product is complete.
TT/TR3000 Environmental Specifications
MTBF: >100,000 hours
Operating Temp: -40˚C to +74˚C
Storage Temp: -40˚C to +85˚C
Relative Humidity: 0% to 95% (non-condensing) †
† May be extended to condensation conditions by adding suffix ‘-C’
to model number for conformal coating.