Interlogix VDP-MSP Series - Manual

1 of 12
© 2010 GE Security, Inc.
P/N 1069680 • REV 1.0 • ISS 14APR10
GE
Security
Multi-Channel VPD
Combiners Installation Sheet
Introduction
GE Security Multi-Channel VPD Combiners combine video, PTZ data, and camera
power over a single 4-pair UTP cable to simplify CCTV installations in a structured
wiring environment. They support up to 16 cameras. The GEC-8VPDCHUB and
the GEC-16VPDCHUB models come with built-in AC power supplies. They receive
110/220 VAC power and provide up to 16 ports of 24/28 VAC isolated power to
the cameras. Each port is individually equipped with a resettable fuse plus a 2A
glass fuse that is easily accessible from front.
For short runs install the GEC-16VPDCHUB close to the video receiver unit at the
control end. For long runs place the GEC-8VPDCHUB or GEC-16VPDCHUB at a
mid span point close to the camera end to minimize the loss of voltage over
twisted pair.
The following model numbers are covered in this document:
• GEC-4VDPC
• GEC-16VDPC
• GEC-8VPDCHUB (powered)
• GEC-16VPDCHUB (powered)